RTI TheaterTouch T2 Instrukcje Operacyjne Pobierz pdf (Strona 18)

T2+ Universal System Controller

If the T2+ battery capacity is reduced to approximately one hour

of remaining run-time, a low battery icon will appear in the upper

left corner of the display:

The docking station LED illuminates to indicate a charge in

progress. The LED will turn off when the battery in the unit is

fully charged.

A fully discharged battery will take approximately 2-4 hours to

completely re-charge.

The T2+ can remain in the docking station indefinitely without

damage to the battery.

GETTING STARTED

Start by inserting the battery connector into the mating plug on

the T2+. Make sure the connector is oriented properly before

attempting to insert it.

The T2+ is powered-up by touching any area of the display or any

keypad button. If the tilt sensor is enabled, picking up the unit

will also turn it on.

Operation

BEEPER

This button displays a window that allows you to turn the audible

beep on or off. The beeper provides feedback that a button was

pressed. Press the

button in the window to close.

TIME OUT

This button displays a window that allows you to adjust the

amount of time the unit stays awake after the last button press.

The time is variable from 1 second to 60 seconds (the default is 10

seconds). Press the arrows to the left or right of the Time Out

setting to adjust the time. Press the

button in the window to

close it. During Sleep mode, the T2+ uses virtually no battery

power.

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 27 28

Brak uwag

RTI TheaterTouch T2 Instrukcje Operacyjne Strona 18