RTI T1-B Instrukcje Operacyjne Pobierz pdf (Strona 11)

It’s Under Control

CHAPTER 2 | INTRODUCTION

IMPORTANT NOTES

Please read these important notes about the T1-B:

The T1-B should be placed in an area where it is around normal room

temperature (between 60° F to 90° F).

Do not let the T1-B get wet. It should not be handled with wet hands or

placed in an area where it could get wet.

Do not subject the T1-B to smoke, dust, or vibrations.

Only use the power supply that is provided with the T1-B. Using the wrong

type of power supply may result in damage to the battery or electronic

components.

Do not disassemble the unit. Service of the T1-B should be performed by

authorized personnel only.

COMPATIBILITY

The T1-B and Integration Designer

software are compatible with infrared

(IR) commands with carrier frequencies between 15KhZ and 460KhZ, as well

as those commands that do not use a carrier. This covers virtually all of the

remotes that exist to date.

SOFTWARE REQUIREMENTS

The recommended minimum system requirements needed to run the

Integration Designer

software are as follows:

Windows XP

, Windows Vista

or later version of Microsoft operating

system.

CLEANING

To clean your T1-B, lightly dampen a lint-free cloth with a mild detergent, and

wipe the keypad and outer surfaces.

BATTERY AND DOCKING STATION

The T1-B uses a Lithium-Ion rechargeable battery. This battery does not exhibit

any type of “Memory Effect” from being charged too often. Since the T1-B can

safely be charged after each use, a docking station is included for convenience.

If left out of the docking station, the T1-B will remain in sleep mode for 1 – 2

months before shutting down. At that point the battery must be recharged.

If the T1-B battery capacity is reduced to approximately one hour of remaining

run-time, the Status LED will illuminate red while the unit is powered-up.

The T1-B Docking Station can be placed on a at surface such as a shelf or

table, or it can be mounted to a wall using the included mounting bracket. The

docking station LED illuminates red to indicate a charge in progress. The LED

will illuminate blue when the battery in the unit is fully charged or does not

need to be charged, unless the backlight dip switch located on the bottom of

the docking station is set to the “off” position. A fully discharged battery will

take approximately 2-4 hours to completely re-charge.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 23 24

Komentarze do niniejszej Instrukcji

Brak uwag

RTI T1-B Instrukcje Operacyjne Strona 11

Komentarze do niniejszej Instrukcji

Powiązane produkty i podręczniki dla Zdalne sterowanie RTI T1-B